The Stain Library

How to remove lipstick from Laminate Flooring

  • DifficultyEasy
  • OutlookOften removable
  • MaterialLaminate flooring
  • Reviewed2 September 2026

The short answer

Lift lipstick from Laminate Flooring with a blunt edge, blot without rubbing, then use a very small amount of diluted washing-up liquid only if the care label or finish permits water. Rinse by blotting and air dry.

If it has just happened

Lift lipstick from Laminate Flooring towards the centre with a blunt edge, then blot straight up with a white cloth. Do not rub, add heat or use make-up remover while the material and finish are still unconfirmed.

Heat can set this stain permanently

Do not use hot water, a tumble dryer, an iron or a steam cleaner until the mark has gone. Heat fixes this type of stain into the fibres and makes it far harder to shift.

Test on a hidden area first

Try any cleaner on a hidden part of the material first, such as a seam, an offcut, inside a hem or under a piece of furniture. Wait for it to dry and check for colour change before treating the visible mark.

Lipstick formulas vary

A traditional wax stick, tinted balm and long-wear liquid lipstick contain different proportions of wax, oil, silicone, film former and dye. Lift the bulk first and do not compensate for slow transfer with stronger untested chemistry.

What you will need

  • White absorbent cloths Use clean sections so red pigment and any material dye transfer remain visible.
  • Blunt spoon or plastic edge Lift the waxy deposit without cutting fibres or scratching the finish.
  • Washing-up liquid Use one or two drops in water, not a concentrated pool.

Fresh lipstick on laminate flooring

Act before lipstick wax, oil and dye migrate further into the material.

Go carefully with warm water

Laminate flooring tolerates warm water only within limits. Keep contact time short, work from the edge of the mark inwards and stop if the material changes.

  1. Lift rather than wipe

    Use a plastic edge to remove the waxy layer so coloured pigment is not spread across the finish.

  2. Test a weak solution

    Mix one or two drops of washing-up liquid into a cup of lukewarm water and test it out of sight. Continue only if gloss, colour and texture remain unchanged.

  3. Wipe with little moisture

    Wring a soft white cloth very well and work gently over Laminate Flooring. Do not pour cleaner onto a surface, joint, seam or unsealed edge.

  4. Rinse and dry

    Wipe once with a separate barely damp cloth, then dry at once. Stop if the surface becomes tacky, pale, dull, swollen or softened.

  • How longAbout 20 to 40 minutes plus drying
  • RepeatingRepeat the complete route once only when the first pass clearly improved the mark.
  • Stop ifStop at once if colour, gloss, nap, print, coating, adhesive, shape or surface texture changes, or if the second pass makes no further difference.

Dried lipstick on laminate flooring

Lift dried surface wax before adding any compatible cleaner, then make one controlled treatment.

Go carefully with warm water

Laminate flooring tolerates warm water only within limits. Keep contact time short, work from the edge of the mark inwards and stop if the material changes.

  1. Soften the edge carefully

    Rest a cloth barely dampened with weak soapy water over the mark for one minute, then lift softened residue with a plastic edge.

  2. Test a weak solution

    Mix one or two drops of washing-up liquid into a cup of lukewarm water and test it out of sight. Continue only if gloss, colour and texture remain unchanged.

  3. Wipe with little moisture

    Wring a soft white cloth very well and work gently over Laminate Flooring. Do not pour cleaner onto a surface, joint, seam or unsealed edge.

  4. Rinse and dry

    Wipe once with a separate barely damp cloth, then dry at once. Stop if the surface becomes tacky, pale, dull, swollen or softened.

  • How longAbout 20 to 40 minutes plus drying
  • RepeatingRepeat the complete route once only when the first pass clearly improved the mark.
  • Stop ifStop at once if colour, gloss, nap, print, coating, adhesive, shape or surface texture changes, or if the second pass makes no further difference.

Old or set in lipstick on laminate flooring

A set-in red shadow may be dye below the surface or finish damage, so make one final controlled pass and stop if it does not improve.

Go carefully with warm water

Laminate flooring tolerates warm water only within limits. Keep contact time short, work from the edge of the mark inwards and stop if the material changes.

  1. Soften the edge carefully

    Rest a cloth barely dampened with weak soapy water over the mark for one minute, then lift softened residue with a plastic edge.

  2. Test a weak solution

    Mix one or two drops of washing-up liquid into a cup of lukewarm water and test it out of sight. Continue only if gloss, colour and texture remain unchanged.

  3. Wipe with little moisture

    Wring a soft white cloth very well and work gently over Laminate Flooring. Do not pour cleaner onto a surface, joint, seam or unsealed edge.

  4. Rinse and dry

    Wipe once with a separate barely damp cloth, then dry at once. Stop if the surface becomes tacky, pale, dull, swollen or softened.

  • How longAbout 20 to 40 minutes plus drying
  • RepeatingRepeat the complete route once only when the first pass clearly improved the mark.
  • Stop ifStop at once if colour, gloss, nap, print, coating, adhesive, shape or surface texture changes, or if the second pass makes no further difference.

What not to use on laminate flooring

  • Heat before every trace is gone

    An iron, dryer, steam cleaner, hairdryer or hot vehicle can drive the oily dye further into fibre or finish. Air dry and inspect first.

  • Make-up remover, nail varnish remover or acetone

    A product safe on skin or nails can dissolve material dye, adhesive, plastic, paint or finish and can carry lipstick into a wider ring.

  • Hard rubbing or scrubbing

    Rubbing spreads wax and dye, damages pile and coatings, and can leave a pale scuffed patch which is more permanent than the lipstick.

White compared with coloured laminate flooring

Red, pink and brown lipstick pigment may look weaker while Laminate Flooring is damp. Let every hidden test and treatment dry fully before deciding whether colour or finish has changed.

If the mark is still there

Repeat one complete treatment only when the first pass clearly improved the mark. If a second pass makes no change, stop. A fixed shadow may be dye below the surface, retained oil, dye loss, a dull coating or a tide mark, and stronger household treatment can turn a limited mark into a larger repair.

When to stop and call someone

Stop and call a suitable cleaner, conservator or repair specialist if Laminate Flooring is valuable, antique, dry clean only, larger than a palm-sized area, has an unknown finish, or changes colour, texture, gloss, nap or shape during the hidden test.

Why lipstick behaves this way on laminate flooring

Lipstick is a combination stain. A representative formula contains emollient oils and silicones, paraffin and synthetic waxes, plus iron oxides and coloured lake pigments. Lifting the solid deposit prevents it spreading, while a small amount of material-compatible surfactant helps release the oily binder.

The method is limited by Laminate Flooring, not by the lipstick. Lift the bulk, wipe with a dilute neutral cleaner and dry. Keep solvent, bleach, abrasive pads and pooled liquid away from seams, wax, printed wear layers and adhesive.

Common questions

Why is lipstick still visible on Laminate Flooring after cleaning?

The oily binder can be gone while red lake pigment remains, or the apparent stain may be a change in dye, gloss or texture. Let the area dry fully and stop after one improving repeat.

Can make-up remover take it out?

Make-up remover is formulated for skin rather than textiles, coatings, leather, paper, stone or wood. Its surfactants, oils or solvents can spread the mark or damage the material, so use a material-compatible cleaner instead.

How many times should the method be repeated?

Repeat the complete method once only when the first pass clearly improved the mark. Stop sooner if colour, finish, texture or shape changes.

Sources

What we checked and when. Where a manufacturer instruction disagrees with anything here, follow the manufacturer.

  1. Maybelline Color Sensational Shine Compulsion ingredients manufacturer

    Manufacturer ingredient list establishing that a representative lipstick combines silicone and hydrocarbon emollients, paraffin and synthetic waxes, plus mineral and lake pigments including iron oxides and red colourants.

    Checked 2 September 2026

  2. American Cleaning Institute lipstick stain guidance trade body

    Cleaning trade body guidance to transfer lipstick into an absorbent towel, treat from the reverse on compatible washable cloth, launder, air dry, and repeat if colour remains.

    Checked 2 September 2026

  3. Ter Huerne oiled wood and cork floor care manufacturer

    Flooring manufacturer guidance that wood, parquet and cork floors need finish-specific maintenance, minimal moisture and compatible care products.

    Checked 2 September 2026

  4. Delta acrylic bathing product care manufacturer

    Manufacturer guidance that acrylic and related plastics can be damaged by acetone, paint thinner and other solvents, so only compatible non-abrasive cleaners should be used.

    Checked 2 September 2026